Foredom LX Hang-Up Motor and H.30 Handpiece, Choice of Speed ControlK8504
Flex Shaft Tool Sets include popular combinations of motors, speed controls, and handpieces - the three key components of a complete flexible shaft machine. Unlike our Pre-Packed Kits, they do NOT come with any accessory assortments, but do include a tube of grease. The K.8301 and K.8301-2 (230 Volt version) are the only sets that come packed in a printed box. All other sets come packed in a white box.
Motor and Speed Control carry a 2 Year Limited Warranty.
1. Series LX Motor:
These permanent magnet motors are specifically designed for high torque/low speed applications, offering more power for jobs like stone setting, wax modeling, and pearl drilling. M.LX, M.LXM, and M.LXB ball bearing motors feature full power and torque from start up and throughout the entire speed range up to 5,000 rpm. They are ideal for use with Foredoms drill presses. They also are well matched with the H.15 and H.15D Hammer Handpieces.
It comes equipped with a motor bale for hanging, and our standard 39" long key tip shafting for connecting to any of Foredoms quick disconnect handpieces.
2. H.30¨ Handpiece:
Foredom's most popular general purpose handpiece features a 3-jaw, geared chuck with a 0-5/32" capacity. Accessory changes are easy with this handpiece using the supplied HPCK-0 Chuck Key.
3. Flexible shaft grease
4. Speed Control:
* Set K.8501 comes with C.TXR Speed Control:
C.TXR looks the same as our standard foot operated controls but it has special electronics that converts AC current from an electrical outlet to DC current, the type required by Series LX motors. This control also has a different style plug that is made to fit the motor's shielded-type plug. The C.TXR features solid state circuitry in a heavy duty plastic housing with an extra wide footprint, low profile, and non-skid pads on the bottom.
* Set K.8504 comes with C.EMX Dial Speed Control:
C.EMX-1 looks the same as our standard table top controls but it has special electronics that converts AC current from an electrical outlet to DC current, the type required by Series LX motors. This control also has a different style plug that is made to fit the motor's shielded-type plug. The C.EMX-1 is a solid state control in a plastic housing that can be positioned anywhere on a work surface. The hand dial is used to adjust and set speed. This manual style control allows you to maintain and return to a desired speed, time and again by marking the setting on the dial.
We Also Recommend
Foredom M.SRM SRM Bench Motor with Built-in Control- M.SRM, Choice of Handpiece